SENT to CAN Kit

1 in stock

£599.00

The kit comes with:

  • X-Analyser 3 ECO for raw CAN receive and transmit
  • Kvaser Leaf Light to USB interface
  • SENT to CAN Configuration Software
  • SENT-to-CAN Interface

 

Kvaser Leaf Light CAN-HS v2

Kvaser Leaf Light CAN-HS v2 – This single CAN channel interface represents one of the easiest and lowest-cost methods of connecting a computer to a CAN bus network. It has a USB 2.0 compliant connector with a 9-pin D-SUB connector. Galvanic isolation as standard. Recommended for use with the X-Analyser 3.

IN STOCK

For Technical Data open the pdf below.

Kvaser Leaf Light CAN-HS v2

WCT Kit Bag small laptop

Neoprene bag for carrying your portable tech

X-Analyser 3 ECO Single Channel

X-Analyser 3 ECO Single Channel

This is a basic CAN, CAN FD or LIN sniffer (depending upon which Kvaser interface you have) that comes free with any Kvaser interface purchase. It has all the capture, playback and transmit functions. The ECO does not have any CAN data base (dbc) or LDF capability. This is single channel only – dongled from the Kvaser interface serial number.  For feature comparison with other versions of X-Analyser 3, please see:

X Analyser  Features

Free Software Resources

SAE J2716 (SENT) to CAN Gateway

A bus gateway featuring two bi-directional SENT (Single Edge Nibble Transmission) channels, two analogue output channels, and a CAN bus interface. The interface’s flexibility allows the user to use it as a PC interface / SENT data logger, a gateway for PLC or a test system, and generally for SENT communication monitoring and simulation. The analogue outputs offer the possibility to directly convert SENT data frame signals into an analogue voltage.

Category:

Description

The kit comes with:

  • X-Analyser 3 ECO for raw CAN receive and transmit
  • Kvaser Leaf Light to USB interface
  • SENT to CAN Configuration Software
  • SENT-to-CAN Interface

A low-cost gateway between two SAE J2716 (SENT) channels and a CAN bus. The device features two bi-directional SENT channels and a CAN bus interface. Fast, Short Serial, and Enhanced Serial message formats are supported.

For More information:

SAE-J2716-SENT-CAN-Interface-Data-Sheet

  • SENT-to-CAN Gateway
  • SENT logger/tester/simulator
  • Two independent SAE J2716 (SENT) channel
  • Each channel configurable as RX or TX
  • Supports Fast and Slow Messages according to SAE J2716:2016 (Fast, Short Serial, and Enhanced Serial)
  • Supports SENT/SPC
  • Configurable SENT channel parameters – Tick Time, Nibble Count
  • 2 analogue output channels (12-bit DAC, 0-4,095 V)
  • On-board remanent memory
  • Intelligent message filtration
  • 1x DSUB9F (CAN), 1x 8-pin terminal block
  • Input power 9-30 V DC
  • 4x LED (3x Status, 1x Power)
  • 1x Reset switch
  • 5V DC output with over-current protection
  • Dimensions 108 x 54 x 30 mm
  • Table or DIN-rail mount
  • Hardware and firmware customization on request